This remade and re-designed rear hub cone is an 8 degree cone to suit the later GP rear hubs and the modern day Series... [more]

This is a  spindle for drum hubs only.    It does not have the shoulder towards one end like the disc spindles do.  ... [more]

This is our MB remade top hat bush for inside a drum and disc hub which comes zinc plated.... [more]

This is a high quality remade disc spindle which is the same length to suit genuine type Innocenti hubs, forks and forks links or... [more]

This washer sits in your fork link to hold your spindle (and hub!) in place so it is important it is the right size... [more]

This is a quality re-made tab washer to secure the nut that adjusts the static brake pad in a standard type inboard disc brake... [more]

This is a remade high tensile grub screw for adjusting the static disc pad... [more]

This is a remade hub distance spacer slightly designed by MB Scooters to improve hub assemblies.    It fits inside the hub and is... [more]

We were all getting sick of using the plastic speedo drives as they rarely lasted.    Original steel ones are very hard to find so we... [more]

This is a set of 3 of new MB designed Rear Hub bearing plates.  Comes in stainless steel.  MBP0470 comes with a flat face one side and... [more]

Set of 4 standard Lambrettta hub studs. These are MB high tensile zinc plated studs.  ... [more]

Zundapp Bella hub/wheel oil/dust seal.  Both front and rear wheels use the same seal on the outside of each bearing. 2 are required per wheel. ... [more]

... [more]

Lambretta Rear brake pivot pin kit for Li brake shoes. Kit consists of: Brake shoe pivot pins with oil grooves, Li, Sx, Tv, special type, MB Brake... [more]

We've had these front brake adjusters remade in stainless steel, this version comes with a Brass knurled nut to look even more standard on... [more]

Rear brake pivot pin kit Gp type shoes, MB Kit consists of; Gp Pivot pin with lubrication grooves x 2, MB Pivot pin 8mm wavy washers x... [more]

Fits all series 3 hubs, but not 2 holed series 1 and 2 hubs... [more]

Set of 4 MB Lambretta extended wheel hub studs for SIP wheel rims. High tensile and zinc plated. ... [more]

Lambretta Bearing for the front hub. Two are required per hub. MB Race-Tour brand.... [more]

This handy kit contains all the parts needed when overhauling an original type inboard disc brake.... [more]

Complete front hub drum overhaul kit using MB products to suit Series 1, 2 and 3 drums.  ... [more]

Complete front drum overhaul kit to suit Gp drum hubs using MB products.... [more]

Complete kit to overhaul your brake shoes front or back. Comes with; Pair, Li, Sx, Tv type brake shoes Brake pivot pin with lubricating slots, MB Brake plate... [more]