Parts index
We stock over 8 Engine bagged kits
You can take the guesswork out of your engine rebuild using our handy engine bagged kits, which contain the right amount of o rings, circlips etc for an engine rebuild.
MBL0545K
This handy engine oil seal kit contains: Drive side - In Viton Small magneto - In Viton Large magneto - In Viton Kick start - In Viton Rear hub... [more]
MBP0190S
This is a set of 3 fibre washers for the crankcase side level, drain and filler plugs.... [more]
MBP0209K
This handy kit contains all the O rings required when you are rebuilding a Series 1 2 or 3 Lambretta engine. The kit includes: ... [more]
MBP0214K
This handy bagged kit contains the correct circlips you need to overhaul a Lambretta engine, including stainless ones to use on the outside of... [more]
MBP0122K
This precision MB linkage kit is designed by Mark Broadhurst and consists of: Adjuster block, new MB type in hardened steel,... [more]
MBGM0293
New for 2013 and the final piece to the jig saw for the ultimate Lambretta ignition. This is the new BGM GP flywheel... [more]
MBP0373K
This kit includes stainless steel sealing plate, pressed plate, gasket, spit rubber grommet, earth tab and the correct fasteners. Everything you need to overhaul the... [more]
MBP0500K
This is a full set of stainless steel studs, made for MB Scooters Ltd 14 x 6mm crankcase side studs, MB 1 x 6mm tailpipe stud,... [more]