Question 1

I currently have the MRB0058K cut down manifold under the panel of my GP 200. I'm running your tea strainer filter but it rubs on the bottom left where the taper on the panel is. Does this intake position the carb in the same place but more recessed or does it position the carb closer to the silent block?  Any ETA on when they will be back in stock?

Can replacement mesh be purchased for the tea strainer filter?

Thanks in advance

MB Scooters · Accepted Answer

These are on stock and bring the carb into a better position for side panels, we have the filter if you can call us

Question 2

Would this give better clearance under the side panel?

MB Scooters · Accepted Answer

You cant get any shorter that would work

Question 3

just bought the rt195 kit to go on my LI will this work with a 28mmphbh and the standard airbox?

MB Scooters · Accepted Answer

Yes it does

Question 4

Hello 
I currently have the BGM racetour manifold and I am trying to fit a Lectron Billetron 29 mm carburetor. It fits but rubs against the flywheel cowling bolt, I need  about 6mm either higher or tilted towards the front of the scooter, how would the position of the carburetor compare with the racetour manifold?
Thank you

Mark Broadhurst · Accepted Answer

Not sure with the Electon carb as we dont use them. Our MB flange manifold fits better but not as you ask. This one should do what you want MRB0058K

Question 5

Hi I’ve rt 230 putting on a billetron  carb I have 30 m PHBH but the rubber manifold is or seems just a bit to big the id of my carb is 35m

Mark Broadhurst · Accepted Answer

We find those carbs are not machined for the Dellorto mounting rubber

Question 6

Hi 

Does this intake offer any performance improvement over a normal rubber mounted one for PHBH Dellorto, or is it jut more practical with filters etc?

Cheers, and merry Christmas

Will

Mark Broadhurst · Accepted Answer

No real performance increase, but a better carb position to the side panel, cowling etc and it gives more function with different rubbers that can be used with different sized carbs

Question 7

Do you do replacement rubbers for these? If so can I have the MB # please

Mark Broadhurst · Accepted Answer

Part number MRB0833

Question 8

Does this manifold interfere with the cylinder cowling airscoop? Do I  need to switch to a GP cowling?

Mark Broadhurst · Accepted Answer

Yes best to swap to a GP cowling or modify the Li type

Inlet manifold, Lambretta large block, rubber mounted with flange type rubber, Dellorto PHBH, PWK 28-30mm, Race-Tour MB