Lambretta Inlet manifold, large block, rubber mounted with flange type rubber, Dellorto PHBL 22-26mm, Race-Tour MB
MB flange type large block Race-Tour inlet manifold with flange rubber.
Suits Dellorto PHBL carbs 22, 24, 25 and 26mm.
WILL NOT FIT 26mm PHBH FOR THAT YOU WILL NEED MRB0919K
Perfect for MBgm Race-Tour 195/200 - 225/230 cylinder kits.
Fits all large block 200 inlet stud spacings
Advantages
- Fits with all types of cowlings (some may need tweaking)
- Fits with petrol tap rod
- Flange rubber locates inside the inlet manifold
- Fits with the air filter box (will need drilling to let air in)
Designed by Mark Broadhurst to give the best clearance from engine to side panels.
Kit comes complete with
- Die cast polished inlet manifold, MB
- Flange rubber, 22 - 25mm MB
- Stainless steel fasteners, MB
- Stainless steel jubilee clip
TIP: For safety use gasket sealer on all joints, retighten the fasteners after some miles
TIP; Always fit a carb dry, if youre jetting in the bike and constantly removing the carb - wipe clean and dry the rubber and the carb. Always use wide jubilee clips! Tighten just so the carb doesnt move side to side by hand to prevent rubbers splitting. Always carry a spare and use a MB carb support.
