Carb Inlet mounting rubber, Dellorto PHBL, TMX 24mm, Race-Tour MB
£14.88
£12.40
In stock
SKU
MBP0160
Mounting carb rubber, 25mm, MB 22-26mm Dellorto PHBL, Only use wide Jubilee clips
This Mark Broadhurst redesigned, improved and strengthened Viton carb mounting rubber which suits all Dellorto 22 - 26mm PHBL carbs.
It also fits the Mikuni 24mm TMX.
It comes marked with MB.
Fits 30mm spigot outside diameter, lipped one end for the carbside straight on the other.
The rubber measures 36mm in length.
You will need this clip: MBFJC25*40ZC
TIPS:
1. Make sure both inlet manifold and carb are clean and dry before fitting
2. Always use the wide type Jubilee clips
3. Do not over tighten the clips
4. Always carry a spare
5. Regularly lightly twist the carb to check for splits
6. Support the base of the carb against the cowl to hold the weight of the carb
| Brand | MB Products |
|---|
Write Your Own Review
Related Products
