Inlet manifold, Lambretta large block, rubber mounted, Dellorto PHBL, Mikuni TMX 24mm, Race-Tour MB
£27.64
£23.03
In stock
SKU
MRB0050K
Inlet manifold 25/200 Dellorto PHBL, CUTDOWNS/CHOPPERS Not for Airbox
This manifold will let you fit a 25mm (22/24mm) PHBL Dellortos, 24mm Mikuni carburetors onto a 200cc type cast cylinder (Factory, RT, Rapido, Mugello or Original barrel).
It comes with a stainless steel long bolt to replace the long inlet stud, otherwise it is very hard to fit the manifold without dropping the engine.
One of many Inlet manifolds designed by us MB, Ideal for a cut down, chopper or no panelled type Scooter where you can use a remote filter as the inlet manifold is shaped for flow into the intet manifolds. Not ideal for full body Scooters apart from Series 1/2 types.
NOTE; if using a Li type head cowl the air scoop will need shaping, or use a GP type head cowl or even better a MB Carbon head cowl.
| Brand | MB Racetour |
|---|
Write Your Own Review
- Tried and tested.
- Easy to fit.
- Fits many carb applications.
- As used by most dealers around the world for over 20+ years.
- Mark Broadhurst has designed and manufactured more inlet manifolds to suit Lambretta scooters than anyone else.
- Developed over time to suit various carburettors used on Lambrettas for different applications.
- Designed to clear all frame, engine and body parts.
- Reshaped to clear panels.
- Either use an inlet gasket or Silicone sealer to seal the manifold.
- Match the inlet manifold to inlet port and inlet port to inlet manifold for better results.
- Tighten inlet screws together.
