Inlet manifold, Lambretta small block, rubber mounted, Dellorto PHBL, Mikuni TMX 24mm, Race-Tour MB
£20.40
£17.00
In stock
Only 6 left
SKU
MRB0051K
Inlet manifold 25/150 Dellorto inlet for PHBL carbs, MB
We consider the remade 22mm SH carburetors, made by Jetex or Spaco, to be such poor quality that we do not recommend them.
However, the trend is still to keep Lambrettas looking standard so we came across a modern rubber mounted Dellorto that can be used with the standard type Lambretta air boxes.
This manifold fits Small Block engines with these rubber mounted carbs
- 25mm PHBL Dellorto
- 24mm TM Mikuni
- 24mm PWK types
Fits type cast cylinders
- SR 175/190
- Mugello
- Original 125/150/175 barrel
- Casa
This inlet manifold does NOT fit the MB/BGM RT cylinders - these use the larger 200cc type stud spacing.
It comes with a stainless steel long bolt to replace the long inlet stud, otherwise it is very hard to fit the manifold without dropping the engine.
One of many Inlet manifolds designed by us (MB)
| Brand | MB Racetour |
|---|
Write Your Own Review
- Tried and tested.
- Easy to fit.
- Fits many carb applications.
- As used by most dealers around the world for over 20+ years.
- Mark Broadhurst has designed and manufactured more inlet manifolds to suit Lambretta scooters than anyone else.
- Developed over time to suit various carburettors used on Lambrettas for different applications.
- Reshaped to clear panels.
- Either use an inlet gasket or Silicone sealer to seal the manifold.
- Match the inlet manifold to inlet port and inlet port to inlet manifold for better results.
- Tighten inlet screws together.
Related Products
