New MB mag gaskets made from a special stronger material.    Comes in slightly wider 1mm thickness which helps giving some clearance between crank web and... [more]

A new improved mag housing gasket.    Made from 1.5mm thick special material to space out a mag housing.    Some cranks stick out further and some mag... [more]

This set of three MB mag housing gaskets come in 3 thicknesses 0.5 1.00 and 1.5mm.    All engines vary especially new rebuilds cranks vary in... [more]

This is an Indian UNI re-made magneto housing.  The castings are of good quality and machining too   They can be used on any Series 2... [more]

This L shaped washer sits inside your magneto housing and holds one of the oil seals in place.... [more]

This grommet stops water getting into your magneto housing through the top of the the sealing plates.    This fits the original style sealing plates, not... [more]

This grommet fits into your magneto cowl to stop it rattling.  You need 4 per cowl.  A lot of strange engine noises we are asked to... [more]

Made for us to original designs this is a magneto housing gasket for any Series 1, 2 or 3 Lambretta.... [more]

This tab is held to your engine case by the screw for the magneto sealing plate and allows the attachment of an earth wire.    A... [more]

This gasket sits on the top of the magneto housing between the magneto housing and the bottom sealing plate.    Another remade standard MB product.... [more]

Mag housing spacer, Li, Sx, Tv. Made in Stainless Steel. An MB made product.... [more]