Lambretta Tool, 8mm multi purpose T handle screws, Pair, MB

MRB0982PR

These are our multi purpose 8mm T handle screws. 

These are so handy, they can be used all the time on an engine build. Okay you can do all these jobs using a nut, spanner or socket set, but it’s not as easy as using these T handles as you don’t need a tool to use the tool.

There are a few suggested applications:-.

• They are sized so you can easily push it easily through a 16mm piston and small end bearing, which aligns them up to push the gudgeon pin through which saves bending down to get the holes to line up
• Setting port timings and base packers by easily nipping a cylinder down
• Setting ignition timing by using a dial gauge on top of the cylinder
• Sets head gasket size and squish clearance but ideally use 2 pairs for this
• If you have one, easy to hold a rear hub holding tool, or nipping a rear wheel in place
• And if you want you can nip an exhaust in position
•   
• Made in stainless steel so they don’t rust and wipe easy. Slightly sized undersize for a 16mm gudgeon pin. Handles to screw down by hand. 13mm Hexagon on top to set squish clearance with a torque wrench.