Lambretta Crankcase side fastener kit, studs and deep nuts, stainless steel, MB

MBP0227K

This is a full set of stainless steel studs, with nuts made for MB Scooters Ltd

• 14 x 6mm crankcase side studs, MB
• 1 x 6mm tailpipe stud, MB (for clubman exhausts)
• 14 x 6mm MB flange nuts, MB
• 2 x 8mm exhaust studs, MB
• 2 x 8mm flange nuts, MB

The length of the studs suits a normal specification clutch and standard type gasket.

The nuts are taller than normal plain nuts like an original Innocenti but we've added a flange at the bottom so no washers are required and takes out the hassle of using washers.

TIP; Use a stronger loctite on the stud threads and if you want - use a little nut grade loctite on the nuts as an extra precaution but work without it if you tighten them correctly.

TOP TIP; fit the long threaded end into the casing to find more threads especially if the thread is dodgy. Some casings may need tapping further down to let the stud fit correctly. Use tap MBU0915 and tap handle MBU0926