Lambretta Air filter (foam) cone type for large carbs, fits against side panel


This cone air filter can be modified by cutting a small hole just big enough to squeeze tightly over the carbs bell mouth, which will hold it tight and in position.

You need to eye up your carbs angle and side panel from the opposite side to see where the hole needs cutting.

If done correctly the filter will push up against the side panel making it an efficient air filter system.

Ideal for carbs on the left or right hand side and can be modified for all carbs.

Not to be used with holes in the side panel.

Lambretta Air filter (foam) cone type for large carbs, fits against side panel

£ 18.67
Price: £ 15.56 Ex Vat

Reviews ( 2 )


5 star 1. Stephen b 22 Jul 2011 

Nice filter. I use the 35 Mikuni TMX carbs and was fed up of the oil slick on runner board. Sorted it out with this. I just slip the filter over the carb and put panel back on....problem solved. You do have to re-jet the carb though :) Well recommended.


5 star 2. Colin t 26 Jan 2019 

Great product fast post will use again

want to offer a review?
Click here

Questions? ( 5 )

Do you have a Question?

If you would like to ask us a question about this product, please feel free to click here to ask a Question Now!

Peter B on 06 Jun 2022 asked "Will this fit a phbl carb? Or do you have an adaptor for the tea strainer? "

MB Scooters Ltd replied: Yes it will work if there are no holes in the side panels. We dont do a bellmouth for this carb and Tea strainer

Mark o on 06 Jul 2020 asked "I assume that this will be ok for TMX 30 on a series 1...or do you have an alternative?"

MB Scooters Ltd replied: Yes should be fine

Andy A on 09 May 2020 asked "May be a dumb question, but I am assuming that a hole is cut in the grey cone shaped area and slipped over the carb so that the white part of the filter presses / seals against the inside 9f the panel. Bought one and was just needing to confirm this was righ. Thanks in advance Andy"

MB Scooters Ltd replied: Yes correct

Tim on 24 Jun 2017 asked "Will this fit a PHBH, TS1 on a GP with panels and a 13L tank, using a standard manifold?"

MB Scooters Ltd replied: Yes it should be fine

Paul d on 01 Aug 2013 asked "will this fit a 30mm vhsa carb?"

MB Scooters Ltd replied: Yes or one of these MRB0807 which are better

If you feel something is not correct with this product description or image then please contact us using the same link