Lambretta Clutch plate kit (5 plate) (5x3.5mm friction, steels and springs) fits MB 46/47 clutch assemblies, Race-Tour MB
£48.44
£40.37
In stock
SKU
MRB0760K
Clutch kit (5 PLATE) for MB clutch assemblies 3.5mm
This 5 plate clutch kit suits our MB Race-Tour 46 and 47 internal clutch assembly.
This kit should work quite well up around 25bhp.
It comes complete with:
- 5 x 3.5mm MB clutch plates
- 2.50mm MB clutch top plate
- 1 x 2.0mm MB clutch steel
- 2 x 1.5mm MB clutch steels
- 1 x 1.2mm MB clutch steel
- 5 x MB clutch springs
Please note: this is NOT a replacement for a Surflex 5 plate clutch kit for standard clutch assemblies. For standard 5 plate clutch kits for standard crownwheels spiders and pressure plates see MRB0811K
Our 5 plate clutch kit should be used with our deeper clutch spider and deeper pressure plate (as the corks and steels are thicker)
This will not fit a deeper clutch basket if the spider and pressure plate used are standard length.
If you are looking for a replacement Surflex 5 plate kit then please order MRB0811K
Order of assembly starting at the bottom - gear box end:
- 3.5mm friction plate
- 2.00mm steel plate
- 3.5mm friction plate
- 1.50mm steel plate
- 3.5mm friction plate
- 1.50mm steel plate
- 3.5mm friction plate
- 1.20mm steel plate
- 3.5mm friction plate
- 2.50mm clutch top plate
- large clutch circlip
| Brand | MB Racetour |
|---|
Write Your Own Review
- Mark Broadhurst designed these new Race-Tour 4, 5 or 6 plate clutch assemblys
- Fed up with clutch slip we developed these kits
- There was a need for a mass produced precision clutch kit that worked within a budget
- This is a development of the original MRB external clutch kit
This clutch plate kit works with MRB internal clutch assemblies, 46 tooth MRB0759K and 47 tooth MRB0759K
Complete kit consists of
Complete kit consists of
- 5 x Surflex B friction plates
- 4 x Standard 1.5mm clutch steels
- Large clutch spring
- You can reduce the 1.5mm to 1.2mm steels for more clearance
- You can use 6 x Green or Red plates with 5 x 1.2mm steels
- Or you can use 6 x Green or Red plates with 1.2mm steels and 2 x 1.5mm (at the bottom)
- Use a 3mm or 2.5mm top clutch plate
- Always bend the tags down 20/30 degrees on the top clutch friction plate
- Always file 1mm off the first fitted steel plate at five tags to clear fouling the pressure plate
- Make sure both clutch friction, steel, pressure plate fit and slide up and down freely
- Always soak clutch plates in ST90 for 24 hours before fitting