Lambretta Gear box endplate fastener kit, with high tensile bolts and washers
£6.55
£5.46
In stock
SKU
MBP0212K
Gear box endplate fastener kit high tensile bolts, spring washers, MB
We recommend using this set of high tensile bolts to secure your gearbox end plate.
Yes, in theory you should use studs in aluminium but as long as your threads are OK then these bolts will be fine.
You use more of the thread when you use these bolts so your end plate is better attached.
You gain more surface area by only using a plain washer, always use a small amount of loctite on the threads.
| Brand | MB Products |
|---|
Write Your Own Review
Always run a 7x1mm number 3 plug tap into the end plate threads first to clean the threads to remove any debris and make sure there are full threads.
It's very important to remove oil, loose alloy and any old loctite.
Wash out the threads so any bead blast media is fully removed.
It's very important to remove oil, loose alloy and any old loctite.
Wash out the threads so any bead blast media is fully removed.
Related Products
