Carb Inlet mounting rubber, flange type, Dellorto PHBH, VHSH, Bgm

This is a flange type carb mounting rubber from bgm.

Suits all Dellorto PHBH carbs 26, 28, 30mm, Mikuni 30mm and any other carb with similar dimensions.

60mm between hole centers.

You will need this clip MBFJC30*45ZC - If you are using a smooth ring you will need the slightly bigger Jubilee clip 

TIP; Always fit a carb dry, if youre jetting in the bike and constantly removing the carb - wipe clean and dry the rubber and the carb. Always use wide jubilee clips! Tighten just so the carb doesnt move side to side by hand to prevent rubbers splitting. Always carry a spare and use a MB carb support. Always use fuel resistant sealer on the rubber.