I have a question about "25 / 200 - 250 Dellorto complete jetted carb kit" is this kit suited for SIL GP200 stage 4 engine...is it ready just to bolt on and go....how much for postage to Australia...would current throttle cable fit currently have a SH2/22 fitted carbi.....cheers Mike

This carb kit like all our carb kits come pre-jetted on the rich side so all engines can be set up. It also comes with running in and jetting information. It is a complete carb ready to fit all you need is a cable. Black BL1405BL

Hi, Iâ€™ve got a 1981 serveta jet 200 with stage 4 tune/dellorto SH2 22mm carb and considering upgrading to this newer 25 (when in stock). The air filter is on the side of the toolbox and reasonably new, so can I connect this ok? Touring and reliability over performance! Thanks and regards Tim

Ive not tried one but it should fit

Hi I am planning a racetour 190 conversion on a small block with mb clubman + tv gears This will be for town/touring. Therefore i hesitate between 25mm an 28 mm carbs. What would you advise? Regards Regards

If you do not want the best acceleration and top end speed as it is for town/city use then use the 25mm

If I already have a standard 22mm Jetex Carb do I actually need to upgrade the inlet manifold, air filter and connector hose etc. for the 25mm? Or would the standalone 25mm carb not simply swap in as is? If I went for 28mm I presume the full kit would be required? Andrew.

The Jetex manifold doesnt fit the carb. The only thing you can reuse is the air bellows

Skip to the end of the images gallery

Skip to the beginning of the images gallery

Dellorto Carburettor kit, Lambretta large block, Flange type inlet manifold, 25mm PHBL

2 Reviews Add Your Review

£264.80 £220.67

Out of stock

SKU

MBD25K7

25/200 Dellorto PHBL carb kit for 200-250cc, FLANGE type FOR STANDARD AIR Box

Details

More Information

Questions (5)

Reviews 2

A complete carburettor kit, contains everything from the inlet gasket through to the air filter.

Ideal as a replacement for old worn out standard carburettors or on a tuned scooter where you want to keep the standard air box to maintain your scooters standard looks.

Suits all large block 200/205/210/215/220/225/230/240 cylinders with the carb on the left side.

Designed to fit all full panelled scooters without cutting holes in your panels.

Comes with;

25mm PHBL Carb stripped and pre jetted
Spare jets to fine tune the motor
Cable choke assembly
Air filter, high flow, MB
Air hose Viton, MB
Air bellows clips, stainless, MB
MB Flange type Inlet manifold and special bolt
MB Flange Viton carb rubber
Carb rubber clip
Inlet gasket, MB

NOTE; if using a Li type head cowl the air scoop will need shaping, or use a GP type head cowl or even better a MB Carbon head cowl. Fit the air bellows after heating up in boiling water so it re shapes to fit.

PLEASE READ THE SETTING UP INSTRUCTIONS AND CARB SETTING UP BEFORE YOU PHONE FOR ADVICE

Click here for Setting up instructions

Carb Comes with;