Lambretta Tool, Drive side crankshaft dummy bearing bush, stainless steel, MB

This is a drive side crankshaft dummy bearing bush tool.

Made in stainless steel for MB so it doesn't rust in the workshop over time. 

Basically it replaces a flywheel bearing on a dry engine rebuild.

• Ideal to set up base gasket/packers
• Ideal to set up head gaskets
• Ideal to check crank rotaion to see if the con rod will touch in the casing
• Ideal to check squish clearances
• Ideal to set port timings and do tuning
• Ideal to set ignition marks

For use with MRB0980

TIP;

• You may need heat on the casing to fit, make sure the crank spins free
• Always check these things on a final rebuld.