Tool, Tubeless tyre holding/fitting, Lambretta and Vespa, MB

A simple holding jig to clamp Lambretta and Vespa 10'' tubeless wheel rims solid so you can hand fit tyres easier than normal.

Designed by Mark Broadhurst and developed in our own workshop.

This tool can be mounted in a vice, on a table/work bench or on the floor or bolted to a stand.

• Screw the rim to holding tool
• Pre warm a tyre
• Soap around the rim and tyre edges
• Push the tyre over the rim into the tyre well
• Push/walk both sides of the tyre over the rim, (may require tyre levers)
• Remove the valve, blow air in to pop the tyre onto the tyre bead
• Refit the valve and re fill with air to desired pressures