Question 1

Hi I have a Moto Guzzi witch has a 3 speed gear throttle system will this fit for 3 speed ?

MB Scooters · Accepted Answer

Hi if your motor is cable operated then yes it should work

Question 2

I have a question about "Dropped, chopper or straight handle bar gear change MRB"
hi,will this work on a vespa engine and do you sell lever's to match? thanks

MB Scooters · Accepted Answer

Our gear change will work on a Vespa if if you use 22mm handlebars, the gear change comes with a clutch lever.

We only keep master cylinders for the other side which includes the lever.

Question 3

Is the pulley size larger than a vega gear change

MB Scooters · Accepted Answer

Yes much bigger more like the size of a standard gear roller if not larger

Question 4

hi, just purchased gear and clutch selector from you . where does the split pin go.?????

MB Scooters · Accepted Answer

It fits at the bottom of the gear change one youve worked out where you want the gear change. 1)split pin 2) small collar 3) main gear change 4) end cap

Question 5

Do you sell a boss or clamp which will fit on a Vespa  , to allow you to fit 22mm handle bars? It needs to be able to have two screw threads so the 22m motorbike handle bar supports will work.
Cheers

MB Scooters · Accepted Answer

It will fit with a Lambretta headset clamp which its designed for, then the main hole needs machining out to suit the Vespa

Question 6

Hi there. Just wondering if you have a matching throttle and break lever assembly
Cheers

MB Scooters · Accepted Answer

We dont keep them I think it was a Yamaha DT125 that matches

Question 7

Hi guys will this work with a 5 speed box.

Cheers.

MB Scooters · Accepted Answer

Yes no problem

Question 8

I have two of these gear change twist grips but neither will fit the handle bars . I have checked with a Vernier and they appear to be 22mm exactly where as the handle bars are 7/8

Mark Broadhurst · Accepted Answer

You can either drill out the tube to 7/8'' or remove the chrome from the bars or return for us to drill out to 7/8'', seems they slipped through the net

Question 9

Mark, do you happen to sell the lever for set up separately?  I have an older version and would like to replace the lever. 

Cheers, Chad

Mark Broadhurst · Accepted Answer

Theres two type long and short MBL0820 and MBL1627

Lambretta Race-Tour Headset (handlebar) dropped, chopper or straight handle bar Gear change, MB