Lambretta Gear linkage adjustable tie bar, MB

This new adjustable gear linkage tie bar designed by Mark Broadhurst is perfect for those engines fitted with a gear selector arm or wishbone which has the splines out causing hard gear selection and setting up the cables.

This easy adjustable tie bar adjusts from the center hexagon.

Tips

• Screw each end on equally
• Make sure the tie bar fits the selector arm, trunnion and swivel
• Grease the running points
• Fit in position, with gears in neutral
• Disconnect the gear cable inners
• Adjust the center hexagon to set the swivel, so if you move through the gears the cables are at the correct working position and not too tight in 1st and 2nd
• Once your happy remove it, locktite the ends and nuts and tighten up once fitted and check again
• Fit the cables and check again