Lambretta Electronic ignition pack kit, (coil, CDI, brackets, mini loom) MB-Scootronics

Lambretta Electronic ignition coil pack kit from MB-Scootronics

This is a very important part of Scootering by improving the not so reliable Lambretta ignitions whatever make they are.

This is an easy fit kit to work on 6volt or 12volt Lambretta ignitions AC or DC.

The kits comes complete with

• Separate electronic coil
• Separate Electronic CDI
• Separate Electronic CDI mini wiring loom
• Stainless steel Left hand frame mounting bracket MB
• Stainless steel Right frame mounting brackets MB, bolts directly to MB electronic mounting brackets or any copies or can be bolted direct to the frame
• HT lead
• Rubber NGL HT cap
• Fasteners 
• Rubber mountings for CDI and Right hand bracket

TIPS - set up your standard internal low tension coil and pick up box and Vespa type CDI for normal running, disconnect and unscrew the Vespa CDI coil and keep it in your toolbox as a back up spare (tape up the Red/White/Green wires that have been pulled out of the CDI coil so no sparks occour near the petrol tank area under the frame and reconnect if anything goes wrong with the new CDI pack.

Set up the new CDI pack as per instructions and use as your main elecronic coil.

Advantages are

• Better easier starting at lower speeds
• Better clean burn from very low revs
• Better constant tickover speeds
• up to 3 degrees advance/retard
• On some engines up to 5% more power spread 

Works from 6volt DC, 12volt AC, 12volt DC with or without battery, 12volt half wave trickle charge regulators and rectifiers.

Can be used on any engine using 6volt or 12volt ignitions AC or DC.

Link for Wiring diagram.