Lambretta Headset (handlebar) grips, TZR type with large heavy round bar ends, stainless steel, pair, Grey, S3, MB
Specially made for MB
These are our new Grey TZR type handlebar grips with large heavy stainless steel bar ends.
Suitable for all Series 3 scooters.
They are slightly longer than standard grips so are best fitted in conjunction with our bar ends.
Designed by Mark Broadhurst in the 1980s to suit hydraulic master cylinder conversions.
A trick to fit grips is to use a squirt of hairspray on the bar - when it is wet it acts like a lubricant but it dries off to act like a glue.
Designed by Mark Broadhurst, these stainless steel bar ends fit all early and late Series 3 headsets.
Simply tap them into your handlebars with a soft hide hammer.
These fit with early handlebars using paddle rods and later Gp type rods.
Designed to fit with our own Yamaha TZR grips, when the grips are fitted peel back the end of the grip, tap in the outer plug and peel the grip back over the plug, this holds the plug and finishes off the end.
Made from stainless steel and polished and are designed to finish off the grips and add weight to stop vibration in the headset.
This version is the heaviest bar end to help reduce vibration.