Carb Inlet mounting rubber, Dellorto VHSB, Race-Tour MB

This Mark Broadhurst redesigned, improved and strengthened Viton carb mounting rubber which suits all 34/36mm Dellorto VHSB carburettors.

Comes marked with MB.

Fits carb spigot 44mm and works with a double or single lip carb.

The rubber measures 36mm in length.
 

You will need 2 x this clip: MBFJC40*60ZC

TIPS: 

1. Make sure both inlet manifold and carb are clean and dry before fitting
2. Always use the wide type Jubilee clips
3. Do not over tighten the clips
4. Always carry a spare
5. Regularly lightly twist the carb to check for splits
6. Support the base of the carb against the cowl to hold the weight of the carb if yu can