Carb Inlet mounting flange rubber, 4 hole, fits MB Shorty reed, Dellorto PHBH, VHSH, MB type, Race-Tour MB

This is our latest one piece carb rubber to suit our MB shorty reed manifolds.

Made from strengthened rubber, it fits inside the reed cage for gas flow.

On the outside it is shaped to reposition the carb away from the side panel to aid clearance when using remote filters and is designed by Mark Broadhurst to be as short as possible to again help clearances.

Suits Dellorto PHBH 26, 28 and 30mm and some VHSH carbs, will also fit PWK's.

These now come in Black.

TIP; Always fit a carb dry, if youre jetting in the bike and constantly removing the carb - wipe clean and dry the rubber and the carb. Always use wide jubilee clips! Tighten just so the carb doesnt move side to side by hand to prevent rubbers splitting. Always carry a spare and use a MB carb support.

You will need this clip MBFJC30*45ZC 

If you are using a smooth ring you will need the slightly bigger Jubilee clip