Lambretta Stepped stud, 6 to 8mm - 17x13x11mm, Lambretta crankcase side tail pipe, stainless steel, MB
£2.84
£2.37
In stock
SKU
MBP0278
Stud, stepped, crankcase side TAIL PIPE 8mm to 6mm 17 x 13 x 11mm, Stainless, MB
A really simple idea from Mark Broadhurst
This Stainless Steel steppped stud can repair the lower exhaust tailpipe thread that usually pulls outs.
Most people dont have a Heicoil or Timesert kit as they are expensive, this is a cheaper repair.
All you need is a drill, 6.5 or 7mm drill bit and a 8 x 1.25mm tap which most have or can borrow.
Drill out the hole, tap down to slightly shorter than the measurement of the 8mm end and screw in the stud by locking two 6mm nuts together, tap it a bit at a time so when its home tight the flat edge is flush with the gasket face.
On final fitting use loctite, a cheap quality method of repairing old threads.
We used 8mm in the casing as this can also repair some threads already repaired which have also gone wrong in the past.
This Stainless Steel steppped stud can repair the lower exhaust tailpipe thread that usually pulls outs.
Most people dont have a Heicoil or Timesert kit as they are expensive, this is a cheaper repair.
All you need is a drill, 6.5 or 7mm drill bit and a 8 x 1.25mm tap which most have or can borrow.
Drill out the hole, tap down to slightly shorter than the measurement of the 8mm end and screw in the stud by locking two 6mm nuts together, tap it a bit at a time so when its home tight the flat edge is flush with the gasket face.
On final fitting use loctite, a cheap quality method of repairing old threads.
We used 8mm in the casing as this can also repair some threads already repaired which have also gone wrong in the past.
| Brand | MB Products |
|---|
Write Your Own Review
Related Products
