Carb Inlet mounting rubber, Dellorto PHBH, VHSH 30, PWK 24-30mm, Race-Tour MB

This Mark Broadhurst redesigned, improved and strengthened Viton carb mounting rubber suits all Dellorto 26 - 30mm PHBH, 30mm VHSA carbs.

Also fits the PWK type carbs from BGM, Stage6, Koso, OKO

You will need this clip MBFJC30*45ZC 

If you are using a smooth ring you will need the slightly bigger Jubilee clip 

Comes marked with MB.

Fits carb spigot 35mm and comes with a single lip both sides.

The rubber measures 32mm in length.

Can come in Black or Brown depending on stock.

TIPS:

1. Make sure both inlet manifold and carb are clean and dry before fitting
2. Always use the wide type Jubilee clips
3. Do not over tighten the clips
4. Always carry a spare
5. Regularly lightly twist the carb to check for splits<
6. Support the base of the carb against the cowl to hold the weight of the carb