A high quality large magneto or inner flywheel seal.

Fits all Series 2 and 3 magneto housings but not Series 1 models.

It's worth changing the small seal while your engine is apart.

Made from Viton to resist modern fuels.

Another MB Race-Tour product.

TOP TIP Always make sure the mag housing fits freely into the engine casing make sure the seal and flywheel side shoulder are greased and oiled and spin the crank as the mag housing is fitted.

More Information
Brand	MB Products

Write Your Own Review

Only registered users can write reviews. Please Sign in or create an account

Longer lasting.
Harder wearing.
MRB quality.

After manufacturing, designing and testing hundreds of performance MRB engines, Mark found when stripping these engines after many miles the only thing in common with each engine was the seals were worn out whilst all the performance parts were perfectly alright.
This minor failure of seals over many miles lead us to develop these new MRB Viton seals.

Fit the seal dry on outer edges.
Grease or oil inner seal faces before fitting.
Oil seal surfaces on crankshaft.
Use a crankshaft puller to fit the crankshaft.
Spin the crankshaft when drawing into place.

Made from special higher wearing Viton rubber.
Doesn't break down with unleaded fuels.