Question 1

Would you recommend this for a Monza 200 with Clubman, or is the 35mm too big. I am using a PHBH 30 right now, but I know that the TMX35 offers about 15mm more clearance between the side panel and carb.

MB Scooters · Accepted Answer

Yes its a bit shorter and you could use it, but the Clubman will restrict it too much.

Question 2

I have a question about "35 / 200 - 250, Mikuni complete jetted carb kit for Reed valves"

Could you supply this jetted to suit a TS1 225 with 50mm Gori "Race" exhaust with end can? Would it require much experimentation with jetting?
If so, is there an easier to live with carburettor that would be more suitable?
Thanks ATM

MB Scooters · Accepted Answer

This carb kit comes completely overhauled and comes with spare main and needle jets.

And it also comes with comprehensive jetting advice.

Question 3

i am building an rb 20 at the moment and have been told to use a dellorto 30mm flat side carb and a franspeed tour exhaust  but  would this carb be a better option for me in terms of performance and throttle responce

MB Scooters · Accepted Answer

Mikuni carbs are concidered the better carb and are a bit easier to set up, should work fine

Question 4

is this too big a carb for my untuned ts1 200?? [ jl3 pipe] or will it be ok

MB Scooters · Accepted Answer

Plenty of people use them and will set up, I think a 28 - 30mm would be better

Question 5

How would this carb preform on a stage 4 ported GP200 engine? Will I be able to mount this carb behind my pannel with a foam filter? What manifold would I use to mount it to a stock cylinder? Would it change the postion of the carb compared to a stock setup.

MB Scooters · Accepted Answer

Yes you could use it, but it could be a little too big for the job, the manifold to go with it is MRB0067K we also do a filter which works MBU0447. It fits in the same position as a standard carb.

Question 6

Hi...Would you recomend fitting one of these to a tuned 225 Rapido with JL3 exhaust. If so what manifold would i need. Also what would i gain over the present 28 mm Delorto.

MB Scooters · Accepted Answer

I would think is its fine you would need this manifold MRB0064K

Question 7

I have a question about "35 / 200 - 250, Mikuni complete jetted carb kit for Reed valves"
Is this a big improvement on the 34mm VHSB carb I am currently running on my stage 4 TS1 225 (MRB cylinder number 893) and will it help reduce spit back?

MB Scooters · Accepted Answer

These are easier to set up than the Dellorto. Spit back should be less especially if the Dellorto was set up wrong.

Lambretta Carburettor kit, reed, Mikuni TMX35mm, open bell mouth