Lambretta Crankcase side and gearbox dowel, MB

This stud is for the crankcase side, you need 14 for most crankcases. If youre using a Clubman then you use 13 and the longer... [more]

This remade stainless steel stud is used to secure the crankcase side at the point below the kick-start when standard exhausts mount to the... [more]

This is a top quality reuseable - standard thickness 0.8mm crankcase side gasket. Fit all Series 1, 2 or 3 crankcase sides (except TV Series... [more]

This is a full set of stainless steel studs, with nyloc nuts and plain washers to secure your crankcase side. 14 x 6mm crankcase side... [more]

This is a full set of stainless steel studs, with nuts made for MB Scooters Ltd 14 x 6mm crankcase side studs, MB 1 x 6mm... [more]

This is an end plate for a GP type Lambretta engine.  It can be fitted to any Series 1, 2 or 3 engine casing if... [more]

Fed up with inferior supplies where we couldn't guarantee size tolerances we made our own. This track/bush is pressed into the gearbox endplate and the... [more]

We recommend using this set of high tensile bolts to secure your gearbox end plate.    Yes, in theory you should use studs in aluminium but... [more]

This is a set of MB 6 high tensile standard gearbox end plate studs that screw into the casing. The nuts and washers are steel to... [more]

This MB tool is designed to make it easy and safe to refit the gearbox end plate bearing with out damaging the bearing.    It's designed... [more]

This circlip is suitable for use to secure the disc actuating arm into a standard Lambretta disc hub and also hold the end plate... [more]

The casing for the Gearbox end plate dowels tend to get damaged quite easily especially if the nuts have come loose and the holes... [more]

The casing for the Gearbox end plate dowels tend to get damaged quite easily especially if the nuts have come loose and the holes... [more]

The casing for the Gearbox end plate dowels tend to get damaged quite easily especially if the nuts have come loose and the holes... [more]

The casing for the Gearbox end plate dowels tend to get damaged quite easily especially if the nuts have come loose and the holes... [more]