Lambretta Inlet manifold carb mounting rubber flange type, Mikuni TMX 35mm, Amal 28-35mm, MB
MRB0819
This is a Mark Broadhurst redesigned, improved and strengthened flange type Viton carb mounting rubber.
Suits all Mikuni 32 - 35mm and Amal 28 - 34mm carbs, and any other carb with similar dimensions but not VHSB Dellorto.
If using this rubber for the Mikuni 35mm we always suggest using MRB0854 spacer ring which pushes in the rubber before the carb so when the clip is tightened is doesnt push the carb off or split the rubber, as the carb spiggot is shorter on the TMX.
Can come in Black or Brown
- Comes marked with MB
- Fits 40mm (38 - 42mm) spigot outside diameter with one single lip
- Rubber measures 26mm in length
- Bolt hole spacing is 60mm
- Fits new type MB TS1 reed manifold
- Fits MB shorty Reed manifold
- Fits LTH, ScootRS reed manifolds and any engine with the same spacings
- Fits new BGM RT manifold
TIPS:
- Make sure both inlet manifold and carb are clean and dry before fitting
- Always use the wide type Jubilee clips
- Do not over tighten the clips
- Always carry a spare
£ 18.54
Price: £ 15.45 Ex Vat