Lambretta carburettor kit, Large block, 28mm PHBH with tea strainer filter and flange type inlet manifold, MB

MBD28K2F

A complete carburettor kit.

This suits all Series 1, 2 and 3 Lambrettas.

Comes with

Carb stripped and pre jetted
Spare jets to fine tune the motor
Cable choke conversion
MB tea strainer filter (can also fit with an air filter box which will need drilling)
MB Gasket
MB Flange type Inlet manifold and special bolt
MB Flange Viton carb rubber
Carb rubber clips
Large float valve

Jets supplied;

55 Idle Jet fitted (spare 50)
128 Main Jet fitted (spare 125, 120, 115)
AV 264 Atomiser fitted (spare AV266)
X13 Needle fitted (spare X7, X7/13, X13/2, X2)

It gives slightly better fuel economy than the 30mm version at the expense of a little bit of top-end speed.

More suited to milder tunes.

Suits all 200/210/215/220/225/230/240 cast type cylinders and all Race-Tour RT 195/200 and 200/205 cylinders.

PLEASE READ THE SETTING UP INSTRUCTIONS AND CARB SETTING UP BEFORE YOU PHONE FOR ADVICE

Click here for Setting up instructions

Lambretta carburettor kit, Large block, 28mm PHBH with tea strainer filter and flange type inlet manifold, MB

£ 230.53
Price: £ 192.11 Ex Vat

Reviews

there are no customer reviews at present
want to be the first to offer a review?
to place a review click here

Questions? ( 4 )

Do you have a Question?

If you would like to ask us a question about this product, please feel free to click here to ask a Question Now!

John on 12 Feb 2024 asked "Hi, what size needle valve coming with this kit please? Thanks "

MB Scooters Ltd replied: Usually a 3 or 3.5mm

John on 12 Feb 2024 asked "Hi, I have the RT225, an expansion tour type pipe, and used 90% of the time in the city. With 5.2 ratio. Is the 28mm ok / better for this then the 30mm ? Obviously want better fuel consumption then top end speed. Thank you"

MB Scooters Ltd replied: Id say 28mm and if you want top speed its still works

Philip F on 11 Sep 2023 asked "MBD28K2F I am currently building an engine using an RT195 kit ..46/16 drive and 42mm clubman exhaust. Is the above carb already jetted to use on the RT195 engine with this configuration. Or can you please advise what the jetting should be? Thanks Philip"

MB Scooters Ltd replied: Our carb kits come pre jetted, but jetted rich and they come with spare jets to weaken off and set up your motor. Our jetting instructions are on our Tech-Site

Shaun on 30 Aug 2021 asked "Hi i am looking for a carb set up for my eibar s2 its got 198 imola and an exbox avanti exhaust with end can what would best carb be and do you sret them up if so how much please regards shaun"

MB Scooters Ltd replied: This kit should be perfect, but ideally you need to measure the inlet holes center to center as these kits vary it may have a small or large block inlet stud spacing

If you feel something is not correct with this product description or image then please contact us using the same link