Lambretta Race-Tour Inlet manifold carb mounting rubber stepped type, Dellorto VHSB to Mikuni TMX35mm/Amal, MB
MBU0089
This Mark Broadhurst redesigned, improved and strengthened Viton carb mounting rubber allows the use of a Dellorto 34/36mm VHSB carburettor on a manifold designed for a 34mm Amal or 35mm Mikuni carburettor (or vice versa).
Comes marked with MB.
Fits carb spigot 40mm single lip on one side TMX/Amal and 44mm single lip on the other (this fits single and double lipped carbs).
The rubber measures 34mm in length.
You will need 2 x this clip: MBFJC40*60ZC
TIPS:
- Make sure both inlet manifold and carb are clean and dry before fitting
- Always use the wide type Jubilee clips
- Do not over tighten the clips
- Always carry a spare
- Regularly lightly twist the carb to check for splits
- Support the base of the carb against the cowl to hold the weight of the carb if you can
- If your using a Mikuni TMX carb then you must fit spacer MRB0854 or the rubber will split!
£ 16.87
Price: £ 14.06 Ex Vat