Lambretta Race-Tour Inlet manifold carb mounting rubber stepped type, Dellorto PHBH to Mikuni TMX 35mm/Amal, MB
MBP0327
MB designed high quality Viton carb mounting rubber.
Simple way to swap carbs if you want to go smaller from say a 34/35mm Mikuni or Amal down to a 28/30mm Dellorto PHBH VHSA 30mm.
Or you can go up from a 28/30mm Dellorto to a 34/35mm Mikuni or Amal.
No need to remove and replace the inlet manifold.
- Large end diameter of spigot is 40mm
- Small end diameter of spigot is 35mm
The rubber measures 30mm in length.
You will need 2 of this size clip: MBFJC32*50ZC
TIPS:
- Make sure both inlet manifold and carb are clean and dry before fitting
- Always use the wide type Jubilee clips
- Do not over tighten the clips
- Always carry a spare
- If your using a Mikuni TMX carb then always fit the spacer ring MRB0854 or the carb rubber will split
Another product specially designed and made from MB.
£ 11.26
Price: £ 9.38 Ex Vat